Welder

Welder JM1

The Welder JM1 welds fabricated sheetmetal components to assemble various sheetmetal parts in the assembly and production of Navy ship repair and other marine and commercial equipment. Welder JM1 must possess trade specific tools.

Essential Functions / Duties

• Reads job specifications to determine machine adjustments and material requirements
• Setup welding equipment
• Fit and tack parts together in preparation for welding
• Remove excess slag
• Perform precise fitting work on components
• Running lines and leads
• Must adhere to a promote ALL company safety policies. Wear all required PPE when in production areas and promote a clean and safe work environment.
• Ensure that employees assigned with firewatch duties are in place and ready prior to begin hot work
• Fill out job JSA forms

Physical Demands

The welder JM1 must be able to meet and successfully perform the essential functions of this job. The following physical demands are representative to the position.

The position is active and requires extensive standing, walking, sitting, bending, kneeling, stooping, crawling, climbing, and crouching. Along with such movements, employee is required to lift parts/machinery of up to 75 pounds. Additional demands are listed below:

• Able to climb ladders and work off scaffolding
• Able to lift, carry, and or push up to 50 75 lbs. throughout the shift (including overtime)

* Reasonable accommodations may be made to enable individuals with disabilities to perform essential functions

Knowledge / Skills

• Must be certified in welding
• Basic blueprint reading and interpret weld symbols
• Ability to weld in all positions
• Ability to troubleshoot minor welding equipment problems
• Must be able to evaluate the use of various resources and make knowledgeable decisions regarding safety and company procedures and policies
• Able to read a tape measure
• Pass welder workmanship training (WWT)
• Able to operate sawzall, 4" & 7" grinders, and various other tools
• Able to use weld gauges
• Must have stainless to stainless, alum & steel TIG certs

Competencies

• Communication proficiency
• Flexibility (job duties & schedule)
• Work well with others in all areas where SCW&M is performing work
• Follow verbal/written instructions
• Teamwork orientation

Supervisory Responsibility

Welder JM1 position has no supervisory responsibilities.

Position Type / Hours of Work

This is a full-time position, 40 hours per week. Schedule is Monday-Friday, 6:00 a.m. to 2:30 p.m. / 2:30 p.m. to 11:00 p.m. (swing shifts dependent on work load). Occasional overtime and weekend work may be required based on production needs.

Required Education and Experience

• Must be certified welder
• Must have a minimum of 1-2 years of ship repair experience and/or skill set.
• Must be able to speak and understand basic English

Work Authorization Clearance

For E-verify and contract security purposes (including ship access lists), all employees MUST present a valid export document. Acceptable documents are U.S. birth certificate, certificate of naturalization, passport, passport card, and permanent resident card.

Other

Please consider that duties, responsibilities, and all other points specified in this description can change at any time with or without notice.